Error Code # |
Error Description |
Possible Fix |
General |
1 |
This error is displayed instead of the Latiude or Longitude.
Most likely caused by an incorrect Map calibration.
Error occurs when software attempts to convert a image coordinate (x,y) to a
Latitude,Longitude. |
Check Map calibration for input errors,
All North/South or East/West entered correctly.
Calibration points not all in horizontal or vertical line (must have good spread across
the map). |
2 |
This error is displayed when attempting to create a Waypoint.
Most likely caused by an incorrect map calibration.
Error occurs when software attempts to convert a Latitude,Longitude to an image coordinate
(x,y). |
As above. |
Printing a Map |
101 |
The temporary windows bitmap needed could not be created. |
Your system may be very low on resources, memory or hard disk space. |
102 |
Printing Error - The image could not be transferred to the printer, this usually means
the section of image being printed causes an error in the windows StretchDiBlit function. |
You may not have enough free disk space on C: drive for the image to be spooled. You
may need many hundreds of megabytes to spool a large image. Free up some disk space or
trying printing with a larger scale. |
103 |
The error occured in the windows Bitblt command. |
Should not normally happen, try a reboot of the computer. |
Saving a Map Image |
110 |
The file where the image is to be save could not be created. |
The file may may already exist and be marked as read-only. |
111 |
There was not enough disk space to create the image. |
Free up some disk space. |
112 |
There was not enough disk space to create the image. |
Free up some disk space. |
113 |
The temporary windows bitmap needed could not be created. |
Your system may be very low on resources, memory or hard disk space. |
114 |
The error occured in the windows Bitblt command. |
Should not normally happen, try a reboot of the computer. |